Ducksy

A sketch to make your Teensy 3.6 Quack! Reads a plain text file from an SD card connected to the built-in slot on the Teensy, interprets commands, and sends HID commands to the connected host.

Supported Commands

Supports all of the commands from Duckyscript (from the USB-Rubber-Ducky project) interpreter with some additions due to the easy support of mouse movement and file system access. All commands are by default read from a payload.txt file that needs to be located on the root of the SD card.

New Commands

• MOUSE: provides for mouse three button click and movement tracking
  • MOUSE CLICK (MOUSE_LEFT|MOUSE_MIDDLE|MOUSE_RIGHT): Press and release a defined mouse button
  • MOUSE TOGGLE (MOUSE_LEFT|MOUSE_MIDDLE|MOUSE_RIGHT): Toggle a defined mouse button, holds the button down until the next toggle command
  • MOUSE MOVE [X] [Y]: Provides relative movement from current position based on x and y coordinates
  • MOUSE MOVETO [X] [Y]: Locates the mouse at an absolute position based on the defined RESOLUTION
• STRINGLN: Same as STRING but ends with a newline to save on ENTER entries
• RESOLUTION [X] [Y]: Supports setting the monitor resolution for MOUSE MOVETO
• FILE: Types out the contents of a file stored on the SD card

Setup

Requirements

• Arduino IDE (developed on 1.8.9)
• Teensyduino (developed on 1.46)
• SdFat library (developed on 1.1.0) for Arduino and an FAT16, FAT32, or exFAT formatted SD card

Deploying with Arduino IDE

1. Install Arduino IDE
2. Install the Teensyduino addon for Arduino
3. File->Open the ducksy.ino file in the Arduino IDE
4. Tools->Board and set to Teensy 3.6
5. Tools->USB Type and set to Keyboard + Mouse + Joystick
6. Tools->Manage Libraries and install SdFat
7. Sketch->Include Library and select SdFat to add the SdFat header includes to the top of the sketch
8. Upload to the Teensy!