A replacement label for the Konix Speedking range of Joysticks.
There are two files in this release
These labels have a 1mm excess around the edges and inside. This is to make it easier to cut out.
Suggested method:
Use Glossy Vinyl Self-Adhesive labels, print in best quality
Once printed, leave to completely dry for 24 hours.
Spray with Clear Lacquer, a light covering at first, then a second, thicker coat about 10 minutes later. Leave to dry for 24 hours.
Cut out with scissors, or a craft knife, and apply.
Second cutting method using a laser:
You can use the image to create a mask for a laser cutter - This is not really recommended as the Vinyl labels should not be used on a laser cutter but I used one as I have plenty of ventilation.
Trace the image in Lightburn
Undersize it by 1mm all round, including the joystick hole.
Cut an outline on the laser onto a spare scrap of card aligned to the top left of the laser.
Use this as a guide to ensure that ther label is centered.
Enjoy your shiny new label! :-)