Release 1.1.2: C2+Enhanced, gateway 2.4.3 compatibility (fix)

Fix over 1.1.1: cloning pairing of the sensors now works again.

Full Changelog: r1.1.1...r1.1.2

Release 1.1.1: C2+Enhanced, gateway 2.4.3 compatibility

• Support for C2+ Enhanced
• Scripts compatible with KAT Gateway 2.4.3
• Use hardware serial if not set anything else
• Script to set arbitrary serial number

Full Changelog: r1.0.3...r1.1.1

Release v1.0.3: with frequency configuration scripts.

This release include scripts that allow to set up frequency.
Update firmware to the latest and then you can run set-freq-* to choose update frequency.
Updates 86Hz are exactly as stock receiver, update 100Hz is little higher and still compatible with stock firmware.
If you want to use 133Hz update rate you need to update sensors firmware.

WARNING: Use Gateway 2.1.5 during installation/configuration as next versions are not compatible. You can update after receiver is configured to any version you want.

Release 1.0.2: fixed pairing

Now it is possible to pair the receiver via Kat Gateway software from scratch to use as replacement device.

Release 1.0.1-133Hz

The stable release working on 133 Hz with sensors.

WARNING: You need to install firmware update to sensors you use.
Follow the instructions inside of README.md file.

This release gives best possible latency reduction.

Release 1.0.0

First stable release of the alternative receiver, working on 100 Hz with stock sensors firmware

Test Release 0.99.0

Initial release version:

• C2 & C2Core versions
• Automatic firmware selection
• Upload existing pairing data