Added ability to display 32 bit integer

[alnyan]

Added both signed and unsigned ints.
Top bus = 16 upper bits
Right bus = 16 lower bits
May be kinda buggy, but everything works fine for me.
(Related to issue #170 )

Edit: I can reformat/refactor some code if needed.

[Victorious3]

Also, what's about the bottom bus? Is it just there for decoration? I want it to be obvious, and for that you'd probably need an indicator inside the GUI and not render the third bus

[alnyan]

I may rework some code so I'll add support for up to 48-bit integers:
then bottom bus will be lower 16 bits, right bus - middle 16 bits, etc.
I didn't change GUI in my pull request. Just added ability to show 32-bit numbers.

[alnyan]

Okay, now correcting mistakes you've mentioned.

[Victorious3]

Looks good so far, but I'd prefer if you could configure it inside the GUI somehow...

What about this: You combine short and int (+48 bit?) into one category and then allow to freely configure the sides. If you only select one its going to be short, two is int and three is your 48bit integer. I'd probably do this with three mode switches that work similar to the CAD, around my render of the segment. Adding to this, you'd also have to change getConnectionTypeAtSide accordingly.

I'm going to pull it anyways, this is just if you want to do it yourself.

[alnyan]

Alright, but I'm very bad at GUI coding. I'll try, though.

[skyem123]

How is progress on this going, @Awesome2K?

[alnyan]

Well, no luck with GUI. My text just doesn't get rendered. Still trying...
I've added something like half-long (48bit) integer, top bus - first 16 bits, left bus - middle 16 bits and bottom bus - last 16 bits.

[Victorious3]

@Awesome2K If you have any questions on it I'd be glad to answer them, just join IRC (server: irc.esper.net, channel: #sapphire)

[Victorious3]

You can't just change these, it would break backwards compatibility. You need to add int to the end as 7/8

[Victorious3]

I'd still prefer a solution where you can change the input sides via the GUI, but I'm going to pull it like this if you don't want to do that.