Connect an RGBs (Red, Green, Blue, CSync) signal over BNC and Stereo Audio signal over RCA to your RetroTINK-5X Pro through the side SCART connection.
Typical use case would be with a Extron Crosspoint or daisy-chain from the output of a PVM, TTL CSYNC only (jumper included for 75 ohm CSYNC). Connections are turned 90° so they are facing backwards, creating a simple and clean cable management path in your entertainment system.
Fully assembled and QC tested BNCtoSCART adapters can be purchased here.
- Input: 4x [BNC] and 2x [RCA]
- Outputs: 1x [SCART]
- PCB Design Files (DipTrace, Gerber)
- 3D Print Files (STEP, STL, 3MF for Bambu Studio)
- Bill of Materials (XLSX)
- Photos
- Solder BNC, RCA and resistor components in place.
- The flat end SCART connector should be aligned with the board edge, ensure it is properly square and aligned and solder in place.
- The jumper must only be closed for 75 ohm CSYNC only, otherwise damage to the RetroTINK-5X Pro may result. Do not close this jumper unless you are absolutely certain of 75 ohm CSYNC.
- Clean the board with isopropyl alchohol, then ultrasonic cleaning is recommended.
- Apply hot glue to fill the void between the bottom of the RCA connector and the top of the PCB.
- Secure the PCB assembly to the shell with (2) of M3x6 screws.
- Screw the shell halves together with (2) of M3x10 screws.
- Ver 1.1 - First production version
- Ver 1.2 - Added sync jumper and screw indication
- Ver 1.3 - Fixed SCART bottom pads alignment (Initial Open Source Release)
- Rev 1 - First production version
- Rev 2 - Modified bottom shell for low profile BNC jacks
- Rev 3 - New internal geometry to print with minimal supports (Initial Open Source Release)
This project is open-source under the CC BY 4.0 (Attribution 4.0 International).
This project is provided "as-is" without any warranty, express or implied, including but not limited to warranties of merchantability or fitness for a particular purpose. No support is provided.
Amazon links are affiliates.