Arduino Light Simulation

Hi Coders,

Take a look at this simulation to experiment with using Arduino code to control a set of NeoPixel lights using the 4 sliderswitches. Each switch controls the state (RED, BLUE, GREEN, YELLOW) as a test circuit. This simulation runs very slow so be patient. You may have to wait a minute after starting the simulation before you see the first light turn on.

https://circuits.io/circuits/3538056-triangle-lights-color-test/

Expected behavior after starting simulation

1. Slide the right most switch to select RED

2. Notice the NeoPixel Current increases to 153mA

3. Slide the rightmost switch to unselect RED.

4. Slide the leftmost switch to select YELLOW.

5. Notice the NeoPixel Current increases to 297mA.