Add The Filter with Sexball Clearance usermod

UserMods/parkycat/THE FILTER with Sexball Clearance/README.md

@@ -0,0 +1,44 @@
+# THE FILTER with Sexball Clearance
+This mod is a modification of [THE FILTER](https://github.com/nateb16/VoronUsers/tree/master/printer_mods/nateb16/THE_FILTER) by nateb16.
+
+I edited the side blower to fit symmetrically with the rest of THE FILTER setup under the bed. 
+
+For the right side version, you can mirror the STLs in your slicer.
+
+I did not have quick disconnect connectors available so everything was wired into Wago with some wire slack for carbon swapping. For secure magnetic mounting, it takes 6 3x6mm magnets.
+
+Parts Needed:
+
+* 5015 Fan, I used GDSTime Dual Ball
+* 6 3x6mm magnets (For Magmount and body, You can get away with 4)
+* 2 Roll-in M3 Nuts (For Magmount)
+* 2 M3x12 Screw, any head (For Magmount)
+* 2 M3x4x5 Heat-set insert or M3 Nuts (For Fan)
+* 2 M3 BHCS Screw of good enough length (For Fan)
+
+Assembly: 
+
+* Insert Heatset insert into the bottom of the 5015 Fan (Or skip and use M3 Nuts)
+* Carefully unclip the top plastic portion of the 5015 Fan
+* Insert Fan into Body.STL and screw in with M3 BHCS
+* Insert Magnets into the mount and body.stl
+* Add carbon and slide in the cover
+* Screw in the magmount to the bed 2020 extrusion
+* Wire as needed and you're done! 
+
+
+Print settings: Voron Standard with no supports.
+
+![](Images/InstalledNoBed.jpg?raw=true)
+
+![](Images/InstalledWithBed.jpg?raw=true)
+
+![](Images/AssembledWithFan.jpg?raw=true)
+
+![](Images/InsideCarbonCubby.jpg?raw=true)
+
+![](Images/VentsView.jpg?raw=true)
+
+![](Images/BackSide.jpg?raw=true)
+
+