G29 doesn't do anyting

[sonjamichelle]

Description

I am using the Extensible UI bracnf. I've compiled it with Visual Studio Code, Everything seems to run correctly from the LCD but when I try to issue a G29 command either via the OctoPrint terminal or within my start gcode it doesn't autolevel. It just homes, heats up and begins the print.

Expected behavior: [What you expect to happen]

Issue G29, Ender3v2 4.22 board, should begin the auto-level routine. Finish heating then print.

It just homes, finishes the pre-heat then begins the print..

Additional Information

MY config.h file:

https://pastebin.com/ygYNQ6Sj