Wantai/Kysan motor distinction still isn't commented in the firmware

[gabegreenwood]

This issue is marked as closed:
#4

But the comment doesn't actually seem to have made it into the firmware. I recently upgraded an old Rostock MAX v1 to what is now effectively a v3, which is great, but ittook me a while to figure out why my extruders were skipping - would have saved me some time if the comment had been sitting there in the firmware where I would have seen it right off the bat. Maybe look into if the commit got lost somewhere along the way?

[brbubba]

Can confirm, here is the original comment:

// ################## RAMBo Digipot Motor current control settings ################
// Values 0-255 (RAMBO 135 = ~0.75A, 185 = ~1A)
// use 140 for xyz and 130 for the E if using Kysan/AutomationTechnology motors and 175 xyz and 200 if using wantai motors

I have an 11/14/16 build and a 12/09/16 build and the comment vanished somewhere between there. This seems like crucial info, especially now that I'm running BOTH Kysan (Extruder) and Wantai (Arms) motors.