PyCubed won't go into bootloader mode #64
Answered
by
maholli
alxklso
asked this question in
Q&A - Firmware
-
|
Hi, I'm trying to updare the firmware on my PyCubed v5 and I'm following this guide, however, when I double click the reset button, it won't go into bootloader mode. The LED keeps blinking green.Any idea what could be going on? |
Beta Was this translation helpful? Give feedback.
Answered by
maholli
Jul 16, 2022
Replies: 1 comment
-
|
Hi @alxklso Does the board otherwise mount properly and operate? You can use the REPL to enter bootloader mode, but it's far easier to get the "cadence" down for the reset clicks. It sounds like your reset clicks are either too fast (too close together) or too slow (too far apart). |
Beta Was this translation helpful? Give feedback.
0 replies
Answer selected by
alxklso
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Hi @alxklso
Does the board otherwise mount properly and operate? You can use the REPL to enter bootloader mode, but it's far easier to get the "cadence" down for the reset clicks. It sounds like your reset clicks are either too fast (too close together) or too slow (too far apart).