ST-LINK V2

[jcardus]

Has anyone managed to burn the firmware using the ST-LINK V2 programmer?

I goes till the end without error, it verifies, but then the beacon doesn't work.

[rolandplanitz]

I'm not exactly sure what programmer I am using, but I see a similar pattern of openocd running without error but nothing sees my nRF51822 tag afterwards.

[jcardus]

My chip is nrf52832, but curiously enough I managed to make it work using the nrf52810 version of the firmware.

So the issue was not in the programmer in my case.