I have flashed the latest Firmware on the Emontx and adjusted the parameters:
- define EMONESP and //#define RFM69CW
- double vCal = 260.00; // for the EU adapter use 260.00
- I am using the CT 100A clamps so iXCal and iXLead left to default
installation overview:
main -> IEM -> EmonTX -> consumers
and on Phase 3 I have my PV installation injecting into the grid most of the time
When I compare the values from a Schneider IEM3155 with the values from the emontx connected after the IEM. I see the following values:
Are these diviations normal for CT readings? Does this firmware identifies direction => PV injection are not? Why is CT4 connected to N is so high?
I have flashed the latest Firmware on the Emontx and adjusted the parameters:
installation overview:
main -> IEM -> EmonTX -> consumers
and on Phase 3 I have my PV installation injecting into the grid most of the time
When I compare the values from a Schneider IEM3155 with the values from the emontx connected after the IEM. I see the following values:
Are these diviations normal for CT readings? Does this firmware identifies direction => PV injection are not? Why is CT4 connected to N is so high?