where can i find the manual for UPS PIco HV4.0B/C PPoE

[carlo-l]

I have a module from a friend who wouldn't start soldering on it
Am now looking for the manual of this module
How and what needs to be soldered for a Pi4 to work with PoE
what software needs to be installed for this module to work

regards
carlo

[PiModules]

Hi, Come back to our website and check tomorrow I release it, as it is still under writing process, same with new firmware, daemons etc BUT PLEASE use our new forum, _as this one is not monitored_ Regarding your question, you need to solder ONLY GOLD Pins PE and RUN, and PoE Connector (4 pins) included in the package. Then install Daemon, and ready. Please repeat this question on our new forum, so I will answer again to you_ _ My Warmest Regards Ioannis

On 02-Apr-22 1:54 PM, carlo-l wrote: I have a module from a friend who wouldn't start soldering on it Am now looking for the manual of this module How and what needs to be soldered for a Pi4 to work with PoE what software needs to be installed for this module to work regards carlo — Reply to this email directly, view it on GitHub <#63>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACBH7BGLDLSX3ZLXOJCLCSLVDARNPANCNFSM5SKYTK5A>. You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

-- Ioannis Pi Modules Raspberry Pi Approved Design Partner www.pimodules.com -- Pi Modules Legal Disclaimer The content of this email is confidential and solely intended for the indicated addressee. Access to this email by anyone else is unauthorized. If you are not the intended recipient be informed that disclosure, reproduction in any form, in part or whole, or circulation of the content of this email is prohibited and may be unlawful. In this case, please inform immediately the sender of the email.