Hello,
I am using scousepy on an ALMA datacube. The spectra has multiple components so I have to use the manual fit in most cases. The manual fit interactive window becomes unresponsive if I go to the previous spectra. The fits are also not shown when I go back. Is going back not allowed during stage 2? As I understand the "refit=True" can be used to look at the plots after stage 2 is complete. Since I have a lot of spectra to fit (>500) I wanted to have the option to check the fitted spectra.
Also once I go to a previous spectrum and try manual fit again, the fit I had done before does not show up (ideally it should show the previous fit parameters and ask if I want to do a re-fit). I am not sure if it was erased.
Example:
I perform the fit manually shown below
I exit the code. I start stage 2 again, but the above fit does not show up when I go back to it. Shown below,
I get the following error in the terminal:
Hello,
I am using scousepy on an ALMA datacube. The spectra has multiple components so I have to use the manual fit in most cases. The manual fit interactive window becomes unresponsive if I go to the previous spectra. The fits are also not shown when I go back. Is going back not allowed during stage 2? As I understand the "refit=True" can be used to look at the plots after stage 2 is complete. Since I have a lot of spectra to fit (>500) I wanted to have the option to check the fitted spectra.
Also once I go to a previous spectrum and try manual fit again, the fit I had done before does not show up (ideally it should show the previous fit parameters and ask if I want to do a re-fit). I am not sure if it was erased.
Example:
I perform the fit manually shown below
I exit the code. I start stage 2 again, but the above fit does not show up when I go back to it. Shown below,
I get the following error in the terminal:
