Misc Documentation Notes

[Jazztache]

Hello! I have some miscellaneous notes about the InputLabs assembly/soldering documentation. I recently assembled a controller, and I had a few issues figuring out a few things.

Soldering

• Where is the battery connector soldered?
• The documentation shows where the battery goes but not the connector for the battery
  • Had to figure this one out without the documentation. Had to de-solder it and put it on the correct side.
  • Having a section in the documentation for this would be nice
• Show pictures of the new right thumbstick
  • Separate the 0.97 and 1.0 into different headings, with different pictures. Or show examples of both under the same heading.

Troubleshooting

• Basic common problems
• What to do if the gyros cannot activate?
  • General troubleshooting advice like changing the gyro button to be something other than the touch sensor would be nice, letting you see if the touch sensor is the issue.

Disassembly

• Common methods to remove the touch hexagon
  • (For moving to different faceplates, for troubleshooting conductivity, e.t.c.)
  • If the touch hexagon cannot be removed, add a note about it. Note: It would be nice if you could use a guitar pick to remove it, since I had to order the hexagon due to the conductive PLA. Would love to be able to move it to different face plates

Sorry if this is a bit general and disorganized, these are notes I collected during the assembly process. Most of these were too insignificant to be anything but one issue request together.