Welcome to sv06 Discussions!

[hillsoftware]

👋 Welcome!

We’re using Discussions as a place to connect with other members of our community. We hope that you:

• Ask questions you’re wondering about.
• Share ideas.
• Engage with other community members.
• Welcome others and are open-minded. Remember that this is a community we
  build together 💪.

To get started, comment below with an introduction of yourself and tell us about what you do with this community.

[Milkman0001]

I am going to install the UBL firmware and wanted to know about the filament sensor support. Where or what port do I plug the filament sensor into when running this firmware?

[JabroNole]

I think there is an issue with using linear advance and s-curve acceleration at the same time. I would disable s curve and see how that works. I tried to compile with those options, but ran into errors in VSC.

[mig82au]

I've tried to build to do exactly that but I have no idea how to compile Marlin. At high speed with a curve, any linear advance causes terrible gaps in the print. Setting LA to 0 greatly improved very fast prints.

…

On Sat, 18 May 2024, 02:14 JabroNole, ***@***.***> wrote: I think there is an issue with using linear advance and s-curve acceleration at the same time. I would disable s curve and see how that works. I tried to compile with those options, but ran into errors in VSC. — Reply to this email directly, view it on GitHub <#6 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AJA3IQYMLFSQMLCL7WLA2OTZCYUFPAVCNFSM6AAAAAAVYLUEFOVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4TINZSHAZDS> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>