Add in option for UBL and filament runout sensor #1
Description
Could a compiled firmware be made that supports UBL for the SV05? I saw you'd mentioned it for the 2.1.1 firmware.
I've noticed on the stock Sovol firmware it probes the bed before it starts printing, but it doesn't do any useful since the Z-axis screw doesn't move at all for the first several layers to take up the differences in the bed. On my SV01 running old CopterTec firmware, it does UBL and does the proper mesh bed as both Z-axis lead screws slowly move back and forth to account for the mesh.
Been having issues with bed adhesion after doing large prints that are 10+ hours long where a corner or two will start to lift off the bed.
Another thing I noticed too was there is a spot for the filament runout sensor on the V4.2.2 silent board that comes in the SV05. Could that be compiled too for your firmware to make that work as well? There's even a spot for the filament runout sensor on the frame already which I find funny since usually Sovols are better equipped out of the box compared to Enders usually.
Anyway, I'd be interested in downloading and flashing firmware that supports UBL and a filament runout sensor. Thanks!