DVI to HDMI adapter for Yaesu Ham Radios
There are reports of folks with Yaesu FT-710 and FT-DX10 damaging their radios while using the DVI video output to HDMI monitor. One big challenge is knowing what is inside the adaptor itself - ie what goes where and if it is active or passive.
This small projects goal was to:
- Make an adapter where the paths inside where known
- Design in/out features to in theory mitigate paths of damage
Included are the schematic with explanations/BOM as well as a gerber file for the custom PCBs
DISCLAIMER: This is all based on my own reserach of HDMI protocols, forum post, and some correspondence with Yaesu Tech Support
Yaesu did NOT provide the pinout guide Yaesu does not endorse this solution Yaesu has not tested this solution
USE AT YOUR OWN RISK/COMFORT!
I assume no liability for any damage caused while using this open source device, user asssumes all the liability.
