JogBox no longer communicates with RRF3.2.2 update

[Shem-GrowLab]

Hello, I've been using the jogbox code to run some buttons and a rotary encoder for my CNC machine thanks to your forums posts. I updated to RRF3.2.2 and it no longer works. I've been trying to figure out what this update broke, but I haven't been able to make any progress. Interested in taking a look?

[g4eml]

Hi, Sorry I did not continue using the Duet after I built the Jog Box. So I am completely out of touch with the project. The jog box just sends G code commands over the serial port so if it has stopped working then either they have changed the way the serial port works or they have changed the commands. That would be the area to look at. Colin. On 28 Feb 2021, at 14:52, Shem-GrowLab <notifications@github.com> wrote: Hello, I've been using the jogbox code to run some buttons and a rotary encoder for my CNC machine thanks to your forums posts. I updated to RRF3.2.2 and it no longer works. I've been trying to figure out what this update broke, but I haven't been able to make any progress. Interested in taking a look? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub, or unsubscribe.

[Shem-GrowLab]

Hi Colin, I think I figured it out. I had to add a line to the config file. It's been great to have on the machine, so thanks for the efforts.

[micromouseonline]

@Shem-GrowLab What line? Where?

[Stout001]

Wondering the same.

[Shem-GrowLab]

Unkind of me, sorry. This was for a previous machine and I’m trying to look back and see what I did.

I believe I added this to the RRF config file, let me know if that is what you’re looking for. If not, I’ll dig in further.

arduino jogbox startup
M575 P1 B57600 S0 ;Jogbox Rotary Encoder PanelDue serial
communication startup at baud rate of 57600