Skip to content

validate_shcd.md

Latest commit

 

History

History
49 lines (35 loc) · 2.22 KB

validate_shcd.md

File metadata and controls

49 lines (35 loc) · 2.22 KB

Validate SHCD

CANU can be used to validate that an SHCD (SHasta Cabling Diagram) passes basic validation checks.

  • The --architecture / -a flag is used to set the architecture of the system, either TDS, or Full.
  • Use the --tabs flag to select which tabs on the spreadsheet will be included.
  • The --corners flag is used to input the upper left and lower right corners of the table on each tab of the worksheet. The table should contain the 11 headers: Source, Rack, Location, Slot, (Blank), Port, Destination, Rack, Location, (Blank), Port. If the corners are not specified, you will be prompted to enter them for each tab.

Example

Validate SHCD

To check an SHCD run: canu validate shcd -a tds --shcd FILENAME.xlsx --tabs 25G_10G,NMN,HMN --corners I14,S25,I16,S22,J20,T39

$ canu validate shcd -a tds --shcd FILENAME.xlsx --tabs 25G_10G,NMN,HMN --corners I14,S25,I16,S22,J20,T39

SHCD Node Connections
------------------------------------------------------------
0: sw-spine-001 connects to 6 nodes: [1, 2, 3, 4, 5, 6]
1: sw-spine-002 connects to 6 nodes: [0, 2, 3, 4, 5, 6]
2: sw-leaf-bmc-001 connects to 2 nodes: [0, 1]
3: uan001 connects to 2 nodes: [0, 1]
4: ncn-s001 connects to 2 nodes: [0, 1]
5: ncn-w001 connects to 2 nodes: [0, 1]
6: ncn-m001 connects to 2 nodes: [0, 1]

Warnings

Node type could not be determined for the following
------------------------------------------------------------
CAN switch

Flags

Option Description
-a / --architecture Shasta architecture ("Full", or "TDS")
--shcd SHCD File
--tabs The tabs on the SHCD file to check, e.g. 10G_25G_40G_100G,NMN,HMN.
--corners The corners on each tab, comma separated e.g. 'J37,U227,J15,T47,J20,U167'.
--log Level of logging. ("DEBUG", "INFO", "WARNING", "ERROR")

Back To Readme