nice!nano w/ battery

[ned-si]

Hey there,

Thanks a lot for the build guide, it's very well made and has been really helpful!

Would it be possible to add information (even without picture) on how to proceed to use a nice!nano with battery while using the power switch tho?

[barbellboards]

Hey there nedsi, Thank you for reaching out. In order to use the power switch with nice!nanos you'll want to solder the battery to the designated battery pads. Here are two ways you can achieve this, one by soldering it to the top pad or, what I consider the preferred way, you can feed the wires through the unused microcontroller holes and solder the batter at the pads under the board. I'll try to add a section showing the two different ways [image: 293852217_599643321874873_5335214776845510241_n.jpg][image: 293042014_472277564737387_4998311413213206782_n.jpg] Barry Campbell Barbell Boards BarbellBoards.com | ***@***.*** <https://www.reddit.com/user/BarbellBoards> <https://www.youtube.com/channel/UCR2bCS8V6J7bVKWIsWdtKaw> <https://www.instagram.com/barbellboards/> <http://twitter.com/barbellboards>

…

On Tue, Jul 19, 2022 at 4:38 AM nedsi ***@***.***> wrote: Hey there, Thanks a lot for the build guide, it's very well made and has been really helpful! Would it be possible to add information (even without picture) on how to proceed to use a nice!nano with battery while using the power switch tho? — Reply to this email directly, view it on GitHub <#3>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AY53N3FTYUP4DWAHA6H2Y7DVUZSQHANCNFSM537DSGUA> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[ned-si]

Thanks for the feedback!

I can't see the images, so I just want to make sure I'm understanding properly:

• battery
  • red wire soldered on the PWR pad
  • black wire soldered on the GND pad

But isn't it enough?

What you're saying is to then we also have to have cables between the b- and b+ holes of the MCU and...? Some of the pad of at the opposite of where the power switch is soldered?