I too have the same sort of open request... wanting to understand the camera interface. What I can tell you that I have learned over the past few weeks is with TELNET 60606 you can get a response from the camera (assuming Wi-Fi is turned on) when you find the valid ip address of the camera. THe first three parts of the ip address you should be able to get from ipconfig /all which might look like 192.168.1.??? where the question marks need to be found for the camera.

Once you have the IP address of the camera the following commands all work but I have not been able to figure out how to get the Folder-Filename of the current last picture captured. So the documentation would be really helpful about now...

telnet 192.168.1.167 60606 returns a blank screen any other ip or port returns a connecting...failed message

This first command will take one picture once you know the ip address (in my case 192.168.1.167)

http://192.168.1.167/cam.cgi?mode=camcmd&value=capture

http://192.168.1.167/cam.cgi?mode=camcmd&value=capture_cancel

http://192.168.1.167/cam.cgi?mode=camcmd&value=touchafrelease

http://192.168.1.167/cam.cgi?mode=camcmd&value=video_recstart
http://192.168.1.167/cam.cgi?mode=camcmd&value=video_recstop

http://192.168.1.167/cam.cgi?mode=getstate

http://192.168.1.167/cam.cgi?mode=getinfo&type=curmenu
http://192.168.1.167/cam.cgi?mode=getinfo&type=allmenu
http://192.168.1.167/cam.cgi?mode=getinfo&type=lens

http://192.168.1.167/cam.cgi?mode=getsetting&type=mf_asst
http://192.168.1.167/cam.cgi?mode=getsetting&type=focusmode

http://192.168.1.167/cam.cgi?mode=camcmd&value=autoreviewunlock

Sorry, I don't have any more to share but maybe this will give you what you are looking for.