Multiple mesh gates

[AventinPrime]

Hello!

Does last versions of firmware supports multiple mesh gates in one network? If not when will you plan to add that feature?

Why I am asking it, cause on the web openmanet.net said that there no support for multiple meshgate while in github nothing was said about it.

[coreywagehoft]

The mesh technically could support it, but we do not actively test it currently. If you have multiple mesh gates, each mesh point will determine the best route to one and use it.

Multiple mesh gates do not provide "load balancing" or increase throughput.

[AventinPrime]

Thank you for answer! So I will try to test mesh network with multiple uplinks.

[AventinPrime]

The mesh technically could support it, but we do not actively test it currently. If you have multiple mesh gates, each mesh point will determine the best route to one and use it.

Multiple mesh gates do not provide "load balancing" or increase throughput.

Corey I downloaded last version of opnemanet 1.6.0 before it was 1.6.0 RC 3 or 4 but I don't understand does it upgraded? I think no cause version of linux kernel is 6.6.102

I've tried to flash it via admin UI and nothing happend. After I tried to make the same via flashcard and still the version of the linux kernel is 6.6.102 What I am doing wrong? How can I check the versions of the batman, alfred etc.

[coreywagehoft]

The kernel didn't change with the full 1.6.0 release. The RC (Release Candidate) versions were for testing before getting to a stable version.

[AventinPrime]

The kernel didn't change with the full 1.6.0 release. The RC (Release Candidate) versions were for testing before getting to a stable version.

So how do I know that I upgraded from RC version to stable? Cause there no any info in admin UI.