When attaching a part, the roll parameter of the second connector is ignored. This is an intentional design choice, as the code is commented with "The rolling angle of the attachable part is not used".
While it doesn't provide any additional capability to use this angle, it's confusing that it's ignored. Is there some reason to ignore it?
When attaching a part, the roll parameter of the second connector is ignored. This is an intentional design choice, as the code is commented with "The rolling angle of the attachable part is not used".
While it doesn't provide any additional capability to use this angle, it's confusing that it's ignored. Is there some reason to ignore it?