These files allow the Inky Frame 7.3" to displayed in a picture frame. It consists of 5 files. They were designed to be laser cut.
-
InkyFrame_7.3_Glass.svg This replaces the glass panel and allows access to the front facing buttons.
-
InkyFrame_7.3_Frame_Mount.svg This is a frame mount to hide the pcb.
-
InkyFrame_7.3_Spacer.svg This is a spacer that goes between the frame mount and Inky Frame so that the Inky Frame sits flush with the frame mount.
-
InkyFrame_7.3_Latches.svg These allow the Inky Frame to stay instead of frame and can be added where ever theres space.
-
InkyFrame_7.3_Back.svg This is a back piece that is optional. However it does let the latches sit flush with the inset.
-
A frame. This has been designed for a 20x15cm frame. Here is the one I used. I am not sure if its compatible with any other frames of that size
-
4x M2 8mm screws
-
4x M2 nuts
-
4x M2 washers
-
3x sheets of 1mm clear acrylic bigger than 20x15cm
-
1x sheet of thick card stock for the frame mount (and something to protect it)