From 3d77c816166c7d516d0508e842aba608ea89a7b2 Mon Sep 17 00:00:00 2001 From: Michael Jansen Date: Wed, 29 Oct 2025 20:26:19 -0400 Subject: [PATCH] Add link to airflow spacer --- docs/p1/index.md | 3 ++- docs/p1/mounting.md | 2 ++ 2 files changed, 4 insertions(+), 1 deletion(-) diff --git a/docs/p1/index.md b/docs/p1/index.md index b9a32d5..9914675 100644 --- a/docs/p1/index.md +++ b/docs/p1/index.md @@ -22,4 +22,5 @@ * [PhotonVision Docs](https://docs.photonvision.org/en/latest/) * [STEP file](files/P1%20Assembly%20Public.step) * [Mounting Diagram](files/P1%20Assembly%20Public%20Drawing.pdf) -* [3D printing files](https://makerworld.com/en/models/1925518-luma-p1-printable-enclosure) \ No newline at end of file +* [Enclosure 3D printing files](https://makerworld.com/en/models/1925518-luma-p1-printable-enclosure) +* [Airflow spacer 3D printing files](https://makerworld.com/en/models/1939322-luma-p1-airflow-spacer) \ No newline at end of file diff --git a/docs/p1/mounting.md b/docs/p1/mounting.md index d847929..2b69653 100644 --- a/docs/p1/mounting.md +++ b/docs/p1/mounting.md @@ -5,4 +5,6 @@ P1 has four 5mm (0.2") through-holes in each corner of the device. These holes c !!! warning When developing your mounting solution, ensure that you do not block the fan grate on the back of the device, or the fan will be unable to properly cool the device. You can either leave a hole in your mount to allow the fan to breath, or use spacers to create some breathing room between the fan and the mount. +A printable spacer with an airflow channel to allow mounting against a surface where adding an air hole is not possible is [available here](https://makerworld.com/en/models/1939322-luma-p1-airflow-spacer). This spacer will also be available to purchase printed with the same high strength, heat resistant filament as the P1 enclosure. + ![Mounting Diagram](img/P1%20Assembly%20Public%20Drawing.jpeg) \ No newline at end of file