I need help with Arduino Mega OTA

[heinsschonhals]

Hello, I am getting the following feedback when I send a sketch via the network port:

"Connecting to board... done
Uploading sketch...done
Flashing sketch... Error flashing the sketch"

I have already changed the timeout but it may not be correct, as this error message comes in approximately 10 seconds, but the following command is given before this message appears:

"C:\Users\heins\AppData\Local\Arduino15\packages\arduino\tools\arduinoOTA\1.3.0/bin/arduinoOTA -address 192.168.3.6 -port 65280 -username arduino -password heins -sketch C:\Users\ heins\AppData\Local\Temp\arduino_build_653848/testeOTA.ino.bin -upload /sketch -b -t 60"

I installed the Megacore bootloader "stk500boot_v2_atmega2560_115200_16000000L.hex", if it's not the correct one, if you could send me the correct bootloader, I've also replaced the arduinoOTA.exe file with version 1.4.1, I think it was in 1.3.0

[JAndrassy]

you need optiboot botloader. not stl500v2

[heinsschonhals]

você precisa do botloader optiboot. não stl500v2

ok, I managed to make sending the sketch to the network port work, but I need to restart the Arduino manually for the new sketch to work, any solution?

[heinsschonhals]

em qual arquivo e qual função chama o watchdog, estou procurando isso agora

copy_flash_pages no bootloader

I'm using a set of optiboot 8 cards, maybe that's it, but it shouldn't work when I restart manually, right?

[heinsschonhals]

I use the following configuration

[JAndrassy]

that doesn't have copy_flash_pages. use MegaCore version or my_boards

btw: the "and after manual reset the new sketch runs?" question was for mcerqueira1509

[heinsschonhals]

que não tem copy_flash_pages. use a versão MegaCore ou my_boards

aliás: o "e após a redefinição manual o novo esboço é executado?" a pergunta era para mcerqueira1509

I found it in your repository, later I will test it and give feedback here if it works to help more people

[heinsschonhals]

Another question, if you have already tested it, sending the sketch outside the local network, through a public IP, would there be a manual way to add the network port to the IDE?

[JAndrassy]

yes. read the README

[heinsschonhals]

sim. leia o README

bingo worked, thank you very much for your help, I will study public IP, this readme from the library folder?