Hi, Ishiwatari, my rapiro is something wrong

[vkjuju]

Hi, Ishiwatari, my Rapiro used to work ok , but after I added a raspberry pi and uploaded a Standard firmware (Arduino sketch) ,it's down as follows, the motor does not move(testing #M1 to #M9 and it turned out to be #E....) , only a noise as shown in the following video, any advice would be appreciated,

btw: it does not work even I removed raspberry pi

https://youtu.be/BUvADcB52WI

[IchiroKano]

Hi, I am Rapiro user.
Are you fix it already? Or did you try following?
Ardino and raspberry pi will conflict with PC.

Thus, turn off the DC power of Rapiro, then PC connect via USB with USB power to Rapiro, then try to upload firmware.

Another way, disconnect GPIO cable from Raspberry pi, then PC connect via USB to Rapiro.

Hope you will fix it.

[vkjuju]

oh, do we have to disconnect cable from pi when we tried command #M1 to #M9? any advice ? thanks

[IchiroKano]

I could re-confirmed; When Raspberry Pi connected with Rapiro, PC can not send serial command, like #M1, to Rapiro, nothing error message appeared of Arduino IDE on Windows. However, I disconnected GPIO 6 pin cable on Raspberry Pi that comes from Rapiro mainboard, PC can send command #M9, Rapiro moved !!

Enjoy in touch with Rapiro