Damage to rubber cover of print head on 3D printer Marcus

[JackiePease]

I put a print on yesterday evening, and left it running for a while - it looked to be ok when I left. When I came in this afternoon there was a horrible mess on the print bed. Thanks to whoever stopped the print at 38% done.
I'm guessing this was caused by the low temperature in the main space, but it would be good if someone else could look over the printer before we try to use it again.
I'll investigate getting a new cover.

[amcewen]

It was me, I left a comment about it on the existing issue with Marcus

It looks like it's skipped on the x-axis a number of times, to me - or were you expecting those steps in the print? Was anything done to remedy #2061 before you kicked off the print? There hadn't been any update on it to say it was fixed

[JackiePease]

Thanks @amcewen

Looks like this is the part. I'll compare with the broken one tomorrow and order if this is the same:
https://ebay.us/m/EFwHdz

[JackiePease]

I've ordered the new part. Due on 3 - 5 January.