Not starting after pause

[jesselee04]

Hello, i have everything installed and setup. when i run ;
./DuetLapse.py -duet 10.1.2.xxx -camera pi -pause yes -movehead 200 200 -detect layer

it stops, moves the head to the corner then never starts again. any advice would be great, thank you!

this is a duet 2 wifi board on a Ender 5 pro using cura slicer.

./DuetLapse.py -duet 10.1.2.xxx -camera pi -pause yes -movehead 200 200 -detect layer

---

• Note "-pause yes" means this script will pause the printer when the -detect or
• -seconds flags trigger.
• If instead, it is desired that this script detect pauses that are already in
• in the gcode, specify:
• "-detect pause"

---

Attempting to connect to printer at 10.1.2.xxx
Connected to a Duet V2 printer at http://10.1.2.xxx

##################################

Options in force for this run:

camera = pi

printer = 10.1.2.xxx

seconds = 0

detect = layer

pause = yes

camparms =

vidparms =

movehead = 200.00 200.00

dontwait = False

##################################

Waiting for print to start on printer 10.1.2.xxx
Will take pictures when printing starts,
and make video when printing ends.
Or, press Ctrl+C one time to move directly to conversion step.

Print start sensed.
End of print will be sensed, and frames will be converted into video.
Or, press Ctrl+C one time to move directly to conversion step.

Requesting pause via M25
Moving print head to X200.00 Y200.00
Capturing frame 0 at X0.00 Y0.00 Z6.12 Layer 6
Requesting pause via M25
Moving print head to X200.00 Y200.00
Capturing frame 1 at X103.69 Y86.69 Z1.32 Layer 7
Requesting pause via M25
Moving print head to X200.00 Y200.00
Capturing frame 2 at X79.03 Y101.37 Z1.52 Layer 8
Requesting pause via M25
Moving print head to X200.00 Y200.00
Capturing frame 3 at X67.97 Y145.27 Z1.72 Layer 9