When using Image Configuration to pre-update tokens, changes to the token's Anchor (both X and Y) are completely ignored if the token's Scale or Mirror Image values are adjusted at the same time. The values remain registered in the Image Configuration menus even after switching, but fail to be applied to the actual token when switching to the new image.
In the screenshot below, the original token had completely default values set (Scale 1.0), while Image Configuration was used to change the token's Scale as well as its Anchor. However, as can be seen, only the Scale change to 0.7 seems to have been applied.
Foundry Version: 13.351
System: D&D5e v5.2.5, PF2e v7.11.2
I've reproduced the issue in three different web browsers (Chrome, Edge, Firefox) and with no other modules but libWrapper enabled.
When using Image Configuration to pre-update tokens, changes to the token's Anchor (both X and Y) are completely ignored if the token's Scale or Mirror Image values are adjusted at the same time. The values remain registered in the Image Configuration menus even after switching, but fail to be applied to the actual token when switching to the new image.
In the screenshot below, the original token had completely default values set (Scale 1.0), while Image Configuration was used to change the token's Scale as well as its Anchor. However, as can be seen, only the Scale change to 0.7 seems to have been applied.
Foundry Version: 13.351
System: D&D5e v5.2.5, PF2e v7.11.2
I've reproduced the issue in three different web browsers (Chrome, Edge, Firefox) and with no other modules but libWrapper enabled.